Hi.
Which is the most power-saving-mode for the C8051F310 uC?
Until now i throttle the oscillator down to SYSCTL/8(~3MHz) and switch the CPU to IDLE-Mode. But the datasheet explains, that it already takes about 155 uA in IDLE-mode at 1MHz. Thats still too much for my application.
I dont have space left for an external oscillator on my board, so switching to a lower frequency isn't possible.
It shall go in sleep-mode and wait until an external interrupt occurs. Then it computes a little and goes to sleep again, until the next external interrupt occurs or the command of waking up arrives.
It should not take more than 10-15uA in sleep-mode.
Is this possible with this device?
Many thanks in advance.
Manuel
Read-Only
Author Andrew Neil
Posted 6-Dec-2004 09:04 GMT
Toolset C51
RE: Power-saving with C8051F310
Andrew Neil
This is purely a hardware device-specific question: you need to speak to the manufacturer (Si Labs; nee Cygnal) about this.
This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.
ARM websites use two types of cookie: (1) those that enable the site to function and perform as required; and (2) analytical cookies which anonymously track visitors only while using the site. If you are not happy with this use of these cookies please review our Privacy Policy to learn how they can be disabled. By disabling cookies some features of the site will not work.