Discussion Forum

Can't connect to target

Details	Message
Read-Only Author Chris online Posted 26-Jan-2004 15:55 GMT Toolset C51	Can't connect to target Chris online Hi, Today I started working with a Cypress EZ-USB FX Development Board. I downloaded devtools version 2.61 After I connected my board to the computer I run EZ-USB control panel and loaded the target with dev_io.hex. I tested it and everything worked just fine. Then I wanted to test the same program in Keil uVision2 V2.10, but without succes. Everytime when I want to go to Debug mode, I get a message that says: Try Again! I've checked the cables and the settings, but I could not find any mistakes. Has anyone had the same problems as I am having now? Kind regards, Chris

Read-Only Author Jon Ward Posted 26-Jan-2004 17:54 GMT Toolset C51	RE: Can't connect to target Jon Ward Does this knowledgebase article help? http://www.keil.com/support/docs/2353.htm Jon