We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Dear Sir/Madam, I have designed a interface board using LPC2294HBD144 for my project. I assembled LPC IC on board. Then I powered on my project board, I found that in Keil IDE, in "Debug-> ULINK2 ARM debugger Setting", I am not able to see any JTAG device chain. Then Manualy, I have added the device ID = 0x4F1F0F0F, Device Name: ARM7TDMI-S, IR len = 4. Then I tried to load to FLASH. It says that "Could not stop ARM device! Check the JTAG Device". I have connected the bootloader pin(P0.14), Boot0 pin(P2.13) and BOOT1 pin (P2.16) to 3.3V through 10K resistor. I have connected RESET pin of controller to 3.3V through 10K resistor and I am giving RESET to controller by connecting it to ground for 1 Second and than leave it. but still same problem is existing.
Please annbody help me out to come out from this problem.]
With regards, Radhe Shyam.