HI i use old RTX 3.12 and use lpc2294 with CAN and is OK but if i use LPC2294/01 whith have new can controller whith have LUT =N-1 i must hand-made RTX i have question HAVE NEW rtx-arm 4.12 improve can driver for LPC2294 and LPC2294/01 or can driver is the same how in rtx-arm 3.12 and will be hand-made can driver for lpc2294/01?
You have to do it yourself, it should be very simple.
i do it hand made ;-) but "new" controller is 7 years old/ but rtx work only old controller ;-( and i think what it must be wrote in doc for rtx ;-)
i think what it must be wrote in doc for rtx ;-)
What "it" would that be? A complete listing of all microcontrolles that might be invented at some point in the future which the documented system won't work on? You're kidding even more than your smiley allows for.
no smile if yu run wizard - you select device -> rtx must select so
The RTX is RTOS and it is up to date for all microcontrollers that Keil has support for, and CAN is just a middleware component that uses RTX and is of course tailored to microcontrollers and supported for most interesting ones.
Also, you can always write your own driver if changing existing one is too hard.