I am using MAC7111 evaluation board for my development.
I am using J-Link for debugging the code with the help of IAR Embedded Work bench.
I was able to flash the code successfully once.
Next time when I tried to flash the code, The IDE is showing an error message saying that
"Unable to halt ARM Core"
Even I tried with "Hardware halt after delay" and "Hardware halt at 0" options..it did not work Please help me in overcoming this problem.
Thanks in advance,
Regards, Naveen
Hmmm... maybe you should be asking on an IAR forum...? This forum is for folks needing help with KEIL tools, not IAR tools ;-]
IAR forum seems not exist.
Yes off course the issue is with IAR but i am trying from all possible ways so i posted here. If any one has come across this kind of situation then they can help me....