File Download Area

RL-ARM SD/MMC File Demo for MCB2400

NOTE: THIS EXAMPLE WILL NOT RE-COMPILE WITHOUT RL-ARM INSTALLED!

This is a Real-Time Library (RL-ARM) Flash File System file manipulation example. You can create, read, copy and delete files from a SD/MMC Flash Memory Card. Also formatting the card is possible. This example project is designed to work with Keil MCB2400 Evaluation Board.

To use this example:

• Connect ULINK2 to the MCB2400 Evaluation Board and power the board.
• Connect MCB2400 Board UART#1 port to PC COM port via serial cable.
• start Hyperterminal session.
  (115200 baud, 8-bits, no parity, 1 stop bit, XON/XOFF).
• In uVision - load the project file and execute Flash - Download.

In the Hyperterminal window you now have a commandline interface to manipulate files on a SD/MMC Flash Memory Card plugged into MCB2400 Evaluation Board. Type Help for a list of available commands.

The SD_FILE program is a standalone application loaded into on-chip flash and available for two targets:

• MCB2400:
  Standalone application for Keil MCB2400 Board using UART#1 port as a communication interface.
  Connect a serial cable to RS232 COM1 port using HyperTerminal at 115200 baud, 8-bits, no parity, 1 stop bit, XON/XOFF.
• MCB2400 RT_Agent:
  Standalone application for Keil MCB2400 Board using RealTime-Agent as a communication interface.
  You can test it only with ULINK2 from uVision debugger.

This pre-compiled version is for target "MCB2400" and may be downloaded using an evalution version of the RealView MDK-ARM package. Note that MDK-ARM Version 3.22 or later is required.