RL-ARM HTTP Demo for SAM7X

NOTE: THIS EXAMPLE WILL NOT RE-COMPILE WITHOUT RL-ARM INSTALLED!

This is an HTTP Server example prebuild for the ATMEL AT91SAM7X-EK Evaluation Board. It also shows how to use the Web Server CGI interface.

This example configures the LAN network parameters for the evaluation board automatically if a DHCP Server is available in your LAN.

To use this example:

• Connect ULINK to the AT91SAM7X-EK Evaluation Board and power the board up
• In uVision - load the project file and execute Flash - Download
• Connect the AT91SAM7X-EK Board to a LAN with DHCP server (most LANs have this)
• Connect your computer to the same LAN
• Open your web browser and enter the address http://sam7x/

This opens the demo page running on the AT91SAM7X-EK Board. Enter:

User name: admin
Password: leave blank

The WEB pages shown are included into the project under HTTP Files group.

The HTTP_demo example is available for several targets:

• AT91SAM7X: Stand-alone (no RTX Kernel) application
• AT91SAM7X Debug: Stand-alone (no RTX Kernel) with debug output
• AT91SAM7X RTX: Configured for RTX Kernel

Note: To debug the application with ULINK2, you need to cut the S2 jumper located near the JTAG INTERFACE connector.

This pre-compiled version is for target "AT91SAM7X" and may be downloaded using a evalution version of the RealView MDK-ARM package. Note that MDK-ARM Version 3.40 or later is required.