Philips LPC22xx A/D Example Program

This example program shows how to configure and use the A/D Converter of the following microcontrollers:

• Philips LPC2210 (executes in internal RAM)
• Philips LPC2290 (executes in internal RAM)
• Philips LPC2212 (executes in internal Flash)
• Philips LPC2214 (executes in internal Flash)
• Philips LPC2292 (executes in internal Flash)
• Philips LPC2294 (executes in internal Flash)

After configuring the A/D Converter, the program reads A/D channel 0 and outputs the converted value using the serial port.

To run this program...

1. Select the device group from the pull-down target list
2. Select the device (Project - Options for Target - Device)
3. Build the project (Project - Build Target)
4. Start the uVision Debugger
5. Open the Serial Window (View - Serial Window 1)
6. Click Run (F5)
7. Click on the Toolbox buttons to change input voltages

A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change.

Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µVision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals graphically.