STMicroelectronics ST10F168 A/D Example Program

This example program shows how to configure and use the A/D Converter of the following microcontroller:

• STMicroelectronics ST10F168

After configuring the A/D Converter, the program reads A/D channel 0 and outputs the converted value using the serial port.

To run this program...

1. Build the project (Project Menu, Build Target)
2. Start the debugger (Debug Menu, Start/Stop Debug Session)
3. View the Serial Window (View Menu, Serial Window #1)
4. View the A/D converter peripheral (Peripheral Menu, A/D Converter)
5. Run the program (Debug Menu, Go)

A debug script (debug.ini) creates buttons that set different analog values in each A/D channel. As the program runs, you will see the A/D input and output change.

Another button runs a signal function that generates a sine wave on analog input 0. µVision3 users may click on the Logic Analyzer tab to view, measure and compare the analog input and output signals graphically.