Infineon C504/C505/C508/C515 A/D Example Program

This example program shows how to configure and use the 10-bit A/D Converter channels of the following microcontrollers:

• Infineon C504-2R/-2E
• Infineon C504-L
• Infineon C505A-4E
• Infineon C505CA-4E
• Infineon C508
• Infineon C515A-4R
• Infineon C515A-L
• Infineon C515C-8R/-8E
• Infineon C515C-L
• Infineon SAB 80C515A
• Infineon SAB 80C515A-5

After configuring the A/D, the program reads all of the A/D Converter channels and outputs the converted values using the serial port.

To run this program...

1. Select the device from the pull-down target list
2. Build the project (Project - Build Target)
3. Start the uVision Debugger
4. Open the Serial Window (View - Serial Window 1)
5. Open the Toolbox (View - Toolbox)
6. Click Go or Run (F5)
7. Click on the Toolbox buttons to change input voltages

A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change.

Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µVision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals graphically.