For Infineon XC2234N-16F — Traps
Simulation support for this peripheral or feature is comprised of:
- Dialog boxes which display and allow you to change peripheral configuration.
- VTREGs (Virtual Target Registers) which support I/O with the peripheral.
These simulation capabilities are described below.
Hardware Traps Dialog
The Hardware Traps dialog shows the state of all MCU hardware
traps. You may select the checkbox of the desired condition to
generate a trap.
Data Type: unsigned char
THE NMIPIN VTREG contains the state of the NMI pin on the
simulated MCU. Normally, the NMI pin is high (indicating that there
is no non-maskable interrupt condition). NMI goes low to signal a
non-maskable interrupt. Enter the following in the Command window to
trigger an NMI Trap using the NMIPIN VTREG.
Enter the following to return the NMI pin to a high level.
Note that on some devices the NMI pin must be low to enter Power