Keil Logo

Peripheral Simulation

For Infineon XC886LM-8FF — External Interrupt Inputs + NMI Control

Simulation support for this peripheral or feature is comprised of:

  • Dialog boxes which display and allow you to change peripheral configuration.

These simulation capabilities are described below.

External / NMI Control Dialog

External / NMI Control

The External / NMI Control Dialog shows the current state of the on-chip external interrupt and non-maskable interrupt controllers. You may change the configuration of these controllers using the controls in this dialog.

External

  • EXICON0 (External Interrupt Control Register 0) holds the parameters that control the external interrupts 0-3 (EXINT0-EXITN3).
  • EXICON1 (External Interrupt Control Register 1) holds the parameters that control the external interrupts 4-6 (EXINT4-EXITN6).
  • EXINTx (External Interrupts 0-6 Trigger Select) selects the interrupt to occur with a falling edge, rising edge or falling edge and rising edge.

NMI

  • NMICON (NMI Control Register) holds the following settings:
  • NMIWDT Enables the Watchdog Timer NMI.
  • NMIFLASH Enables the Flash Timer NMI.
  • NMIVDD VDD Prewarning NMI.
  • NMIECC Enables the Error Correction Code NMI.
  • NMIPLL Enables the Phase-Locked Loop Loss of Lock NMI.
  • NMIOCDS Enables the On-Chip Debug Support NMI.
  • NMIVDDP Enables the VDDP Prewarning NMI.
  • NMISR (NMI Status Register) holds the following status bits:
  • FNMIWDT (Watchdog Timer NMI Flag) is set when a watchdog timer prewarning occurs.
  • FNMIFLASH (Flash Timer NMI Flag) is set when the flash time overflows.
  • FNMIVDD (VDD Prewarning NMI Flag) is set when the VDD is below 2.3 volts.
  • FNMIECC (ECC NMI Flag) is set when an Error Correction Code error occurs.
  • FNMIPLL (PLL NMI Flag) when set, indicates that the Phase-Locked Loop has lost the lock on the external oscillator.
  • FNMIOCDS (OCDS NMI Flag) is set when a JTAG-receiving or user interrupt is requested in monitor mode.
  • FNMIVDDP (VDDP Prewarning NMI Flag) is set when the VDD is below 4.0 volts on 5.0 volt power.

Interrupt Request

  • IRCON0 (Interrupt Request Register 0) Bits 0-6 are set in this register to indicate an interrupt request is active for External Interrupt 0-6, respectively.
  • IRCON1 (Interrupt Request Register 1) indicates active requests for SSC Error(EIR), SSC Transmit(TIR), SSC Receive(RIR) and both ADC interrupts.
Get more information about the
Peripheral Simulation Capabilities
of the µVision Debugger.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.