Keil Logo

Peripheral Simulation

For Infineon C505-2R — Watchdog Timer

Simulation support for this peripheral or feature is comprised of:

  • Dialog boxes which display and allow you to change peripheral configuration.

These simulation capabilities are described below.

Watchdog Timer Dialog

Watchdog Timer

The Watchdog Timer dialog shows the current state of the on-chip Watchdog Timer. You can change watchdog settings using the controls in this dialog.

Watchdog Timer

  • Timer holds the Watchdog Timer value.
  • WDTS (Watchdog Timer Status Flag) is set by hardware when a Watchdog Timer reset occurs.
  • WDTREL (Watchdog Timer Reload Register) holds the refresh value for the Watchdog Timer.
  • WDTPSEL (Watchdog Timer Prescaler Select) is set to divide the Watchdog Timer clock by 16.
  • WDT (Watchdog Timer Refresh Flag) is set to refresh the Watchdog Timer. To perform a refresh, you must set this flag immediately before setting the Watchdog Timer Start Flag (SWDT).
  • SWDT (Watchdog Timer Start Flag) is set to activate the Watchdog Timer. Setting this bit directly after setting the Refresh Flag (WDT) refreshes the Watchdog Timer.
Get more information about the
Peripheral Simulation Capabilities
of the µVision Debugger.
  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.