Keil Logo

Atmel SAM9G35-EK

The Atmel SAM9G35-EK lets designers get a quick start on application development on the ARM926-based Atmel SAM9G35 microprocessor. The kit features the 400MHz SAM9G35 CPU, 1 Gb DDR2-SDRAM, 2 or 4 Gb NAND Flash, one HS (EHCI)/FS (OHCI) USB Host port multiplexed with HS USB Device via Micro AB connector, one HS (EHCI)/FS (OHCI) USB Host port via standard type A connector, one FS only (OHCI) USB Host port via standard type A connector, two Ethernet 10/100 interfaces with on-board MAC controllers and RJ45 socket, two high-speed SD/MMC interfaces, one TFT-LCD module interface, one stereo CODEC interface with line-in and headphone jacks, one telephone/modem interface with RJ11 connector, two serial interfaces (1x USART, 1x UART), one Two-wire Interface (TWI), one ZigBee® extension port and one 5.0" TFT-LCD module with 800x480 resolution, backlight, resistive touch panel, 24-bit RGB interface and four additional QTouch® buttons on board.

http://www.atmel.com/dyn/products/tools_card.asp?tool_id=17324&category_id=163&family_id=605&subfamily_id=1739

Supported Devices

Use the feedback form to tell us about other boards or vendors that should be listed.

  Arm logo
Important information

This site uses cookies to store information on your computer. By continuing to use our site, you consent to our cookies.

Change Settings

Privacy Policy Update

Arm’s Privacy Policy has been updated. By continuing to use our site, you consent to Arm’s Privacy Policy. Please review our Privacy Policy to learn more about our collection, use and transfers
of your data.