Atmel SAM9G15-EK

The Atmel SAM9G15-EK lets designers get a quick start on application development on the ARM926-based Atmel SAM9G15 microprocessor. The kit features the 400MHz SAM9G15 CPU, 1 Gb DDR2-SDRAM, 2 or 4 Gb NAND Flash, one HS (EHCI)/FS (OHCI) USB Host port multiplexed with HS USB Device via Micro AB connector, one HS (EHCI)/FS (OHCI) USB Host port via standard type A connector, one FS only (OHCI) USB Host port via standard type A connector, two Ethernet 10/100 interfaces with on-board MAC controllers and RJ45 socket, two high-speed SD/MMC interfaces, one TFT-LCD module interface, one stereo CODEC interface with line-in and headphone jacks, one telephone/modem interface with RJ11 connector, two serial interfaces (1x USART, 1x UART), one Two-wire Interface (TWI), one ZigBee® extension port and one 5.0" TFT-LCD module with 800x480 resolution, backlight, resistive touch panel, 24-bit RGB interface and four additional QTouch® buttons on board.

http://www.atmel.com/dyn/products/tools_card.asp?category_id=163&family_id=605&subfamily_id=1739&tool_id=17322

Supported Devices

Use the feedback form to tell us about other boards or vendors that should be listed.