Phytec 13. nanoMODUL-164 System on Module (SOM)

Based on the newest developments in SMD and multi-layer technology, the nanoMODUL-164 brings Infineon 16-bit power and CAN connectivity to a very minimal form factor (47 x 38 mm.). Slightly smaller than the microMODUL, the nanoMODUL represents a continuation of PHYTEC's line of miniature Single Board Computers. Based on the Infineon C164CI controller, the board delivers instruction cycles in 100 ns., enabling speedy data throughput. The on-chip 8-channel A/D-converter with 10-bit resolution, Full 2.0B CAN interface and all other controller signals extend to standard-width (1.27 mm.) pin rows (120 pin headers) aligning the board's edges. The pin header rows enable the board to be plugged like a "big chip" into target applications. The standard memory configuration boasts 256 KB (to 1 MB, yet limited to 512 KB if the CAN interface is active) of both SRAM and Flash memory. The module communicates by means of an RS-232 serial interface, which also supports convenient on-board programming of the Flash device, memory mapping and remote software updating. The module requires a single 5 V. power source and operates within a standard temperature range of 0° … +70° C.

http://www.phytec.com/products/sbc/C166-xc166-st10-xa/nanoMODUL-164.html

Supported Devices

Use the feedback form to tell us about other boards or vendors that should be listed.